Steam Engine Simulator – Guide to Perpetual 4287 RPM

How to get perpetual 4287 revolutions per minute.

Perpetual 4287 RPM

How to Do It

Press the “A” in the corner a couple times.

Turn on the heat all the way.

Open the water valve.

Open the throttle to 10%.

Slowly (By that i mean not all at one, I was able to do in less than 30s.) increase the throttle to 56%, what i think is the max for equilibrium.

Wait.

What to Do If You Open the Throttle Too Fast

1. Close the water valve.
2. Drain until the water level reaches the drain.
3. Put the throttle to 20%.
4. When the pressure reaches 100 reopen the water valve.
5. Wait until all the water is gone.
6. Continue as normal.

If all the water is gone but it doesn’t reach 100 psi then add some more water.

You can close the throttle to build up pressure faster.