Submachine: Legacy – Monolith and Stabilizer Locations Guide (Chapter 6)

Guide to monolith and stabilizer locations across chapter 6, spoilers ahead.

Chapter 6: Locations of Stabilizer and Monolith

Disclaimer

It is important that you find the stabilizers after finishing chapter 6 and back track, since mainframe room cannot be accessed again after using the portal to Thoth engraving.

Stabilizer Locations

• Go to this room and rotate the valves until both facing down.

• Go back to the three way tunnel and go down.

• After retrieving the cube, input the following into the screen.

• Go back to this tunnel and it’s on the bottom left (very hard to see).

• From this location, continue left.

• Leave the Thoth room as so and go outside of the sewers, towards left.

• In the mainframe room on the bottom right (very hard to see).

Monolith

• In the 8 room, on the first pod, enable the 54-1 protocol.

• Go back to the start and plug in the old machine, enable 54-5.

• Go to the 54-5 tunnel behind the elevator and input the secrets.

• Go to chapter 8 and warp to layer 7.

• Go back to chapter 6, go to the Thoth engraving wall and go through the portal.